Mahlkonig K30 TWIN Operations Instructions download pdf (Page 20)

Never rotate the grinding discs clockwise fur-

ther then the red mark 1, as the grinding discs

may otherwise be damaged.

7.4 Cleaning of the Grinding Mechanism

After opening the grinder cover the grinding mechanism with the

discs can be vacuumed. Check for foreign objects in the grinding

gear.

Do not change any grinder settings. The discs

could be damaged when re-assembling the

grinder.

Carefully vacuum the grinder casing. Take care not to damage any

cables.

7.5 Grinding Disc Exchange

Grinding disc replacement should only be carried out by autho-

rised specialists or a customer service centre. The „Repair manual

K30 TWIN grinding disc replacement and basic adjustment“ can be

downloaded for replacing grinding discs.

Grinding disc replacement may also be carried out using a replace-

ment (AT) integrated grinder. To do this, order an AT integrated

grinder. On receipt of the AT integrated grinder, remove your inte-

grated grinder from the K 30 TWIN according to chapter 7.6 and

install the AT integrated grinder into the K 30 TWIN. Return your old

integrated grinder in the packaging.

7.6 Removal of The Integrated Grinder

For safety reasons the interior grinders are ﬁ xed to the casing’s

ground plate.

7.6.1 Disconnect the main plug. Close and remove the hoppers. Place

the grinder on its back and unscrew the hex nuts of the motors

(three each). Store the nuts and washers in a safe place. Re-position

the grinder on its rubber feet

7.6.2 Take off the grinder cover (see chapter 7.2)

7.6.3 Release the motors‘ plug-in connectors. Carefully pull the inte-

grated grinder out of the casing.

Do not change any grinder settings. The discs

could be damaged when re-assembling the

grinder.

8. Trouble Shooting For Operating Faults

8.1 Safety Devices of the Grinder

Thermal overload circuit breaker

The motor of the grinder is protected by a thermal overload circuit

breaker which interrupts the motor‘s electric circuit in the event of

electric overload. The display shows an alarm signal. Pressing the

PROG-button or the right single shot button releases the grinder

back to operation mode.

HORECA GASTRO GRINDER

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 28 29

Comments to this Manuals

No comments

Mahlkonig K30 TWIN Operations Instructions Page 20

Comments to this Manuals

Related products and manuals for Straight grinders Mahlkonig K30 TWIN